AGS Fault Codes

From Ashley-KB.com - Ashley's Knowledge Base
Jump to navigation Jump to search

To use this table with ease, please use the Find or Search function of your web browser.

Fault Codes Description
ASG ASG Automatic manual transmission AS-TRONIC
6401 Internal CAN bus OFF
6503 Internal CAN bus: timeout
6703 CAN reception timeout of data of control unit ABS/BS
6803 CAN reception timeout of data of control unit ABS/BS
7003 CAN reception timeout of data of control unit FR
7103 CAN reception timeout of data of control unit FR
7203 CAN reception timeout of data of control unit INT
7603 CAN reception timeout of data of control unit INT
7703 CAN reception timeout of data of control unit FR
6404 CAN bus has overflow.
6405 CAN controller: CAN bus OFF
6610 Faulty interrupt
6611 Fault of control module ASG
6612 Parameters are beyond the valid range.
6613 EEPROM: checksum error
6614 Fault of control module ASG
6615 Internal control module error
1020 Valve Y10: Output has Short circuit to ground.
1120 Valve Y1: Output has Short circuit to ground.
1220 Valve Y2: Output has Short circuit to ground.
1320 Valve Y3: Output has Short circuit to ground.
1420 Valve Y4: Output has Short circuit to ground.
1520 Valve Y5: Output has Short circuit to ground.
1620 Valve Y6: Output has Short circuit to ground.
1720 Valve Y7: Output has Short circuit to ground.
1820 Valve Y8: Output has Short circuit to ground.
1920 Valve Y9: Output has Short circuit to ground.
3020 Sensor 'Gear' has Short circuit to ground.
3120 Sensor 'Gate' has Short circuit to ground.
3220 Sensor 'Range' has Short circuit to ground.
3320 Sensor 'Split' has Short circuit to ground.
4020 Valve Y15: Output has Short circuit to ground.
4120 Valve Y14: Output has Short circuit to ground.
4220 Valve Y17: Output has Short circuit to ground.
4320 Valve Y16: Output has Short circuit to ground.
5420 Output ADVP or ADVP1 has Short circuit to ground.
5520 Output ADM22 has Short circuit to ground.
5620 Output SD has Short circuit to ground.
1021 Valve Y10: Output has Short circuit to positive.
1121 Solenoid valve Y1:Output 'Transmission brake' has Short circuit to positive.
1221 Valve Y2: Output has Short circuit to positive.
1321 Valve Y3: Output has Short circuit to positive.
1421 Valve Y4: Output has Short circuit to positive.
1521 Valve Y5: Output has Short circuit to positive.
1621 Valve Y6: Output has Short circuit to positive.
1721 Valve Y7: Output has Short circuit to positive.
1821 Valve Y8: Output has Short circuit to positive.
1921 Valve Y9: Output has Short circuit to positive.
3021 Sensor 'Gear' has Short circuit to positive.
3121 Sensor 'Gate' has Short circuit to positive.
3221 Sensor 'Range' has Short circuit to positive.
3321 Sensor 'Split' has Short circuit to positive.
4021 Valve Y15: Output has Short circuit to positive.
4121 Valve Y14: Output has Short circuit to positive.
4221 Valve Y17: Output has Short circuit to positive.
4321 Valve Y16: Output has Short circuit to positive.
5421 Output ADVP or ADVP1 has Short circuit to positive.
5521 Output ADM22 has Short circuit to positive.
5621 Output SD has Short circuit to positive.
1022 Valve Y10: Output has Open circuit.
1122 Valve Y1: Output has Open circuit.
1222 Valve Y2: Output has Open circuit.
1322 Valve Y3: Output has Open circuit.
1422 Valve Y4: Output has Open circuit.
1522 Valve Y5: Output has Open circuit.
1622 Valve Y6: Output has Open circuit.
1722 Valve Y7: Output has Open circuit.
1822 Valve Y8: Output has Open circuit.
1922 Valve Y9: Output has Open circuit.
3022 Sensor 'Gear' has Open circuit.
3122 Sensor 'Gate' has Open circuit.
3222 Sensor 'Range' has Open circuit.
3322 Sensor 'Split' has Open circuit.
4022 Valve Y15: Output has Open circuit.
4122 Valve Y14: Output has Open circuit.
4222 Valve Y17: Output has Open circuit.
4322 Valve Y16: Output has Open circuit.
5422 Output ADVP or ADVP1 has Open circuit.
5522 Output ADM22 has Open circuit.
5622 Output SD has Open circuit.
5923 Overvoltage
4424 Fault in voltage supply for clutch sensor.
5924 Undervoltage
3025 Sensor 'Gate' teach-in error
3125 Sensor 'Gate' teach-in error
3225 Sensor 'Range' teach-in error
3325 Sensor 'Split' teach-in error
4425 Clutch teach-in error
2330 New splitter group cannot be engaged.
2430 Switch-over fault when shifting into another gate
2530 New range group cannot be engaged.
2630 Travel signal of main transmission does not match the valve assembly.
2331 Shift cylinder 'Splitter range' fails to reach both the old and the new positions.
2431 Selector cylinder fails to reach the defined position.
2531 Shift cylinder 'Range group' fails to reach both the old and the new positions.
2631 Shift cylinder of main transmission does not reach end position.
3831 Cutout relay in control unit does not switch on, or there is no voltage at terminal 30.
4531 Clutch does not separate.
6031 Control unit ASG does not receive signal 'Ignition ON' even though the engine is running.
2332 Current splitter group cannot be deselected.
2432 Cannot move out of current gate.
2532 Cannot move out of current range group.
2632 Shift cylinder of main transmission does not reach neutral position.
3832 Cutout relay in control unit does not switch off.
4532 Clutch does not close.
2033 Pressure limiting valve has exceeded operating limit.
4033 Mechanical fault of component Y15
4133 Mechanical fault of component Y14
4233 Mechanical fault of component Y17
4333 Mechanical fault of component Y16
4533 Clutch engages when gear is selected even when vehicle is standing still.
6640 Internal error in control unit ASG Automatic manual transmission AS-TRONIC
9140 CAN transmission error of torque request from control module ASG
3441 Rpm signal error: plausibility error
5741 Signals from console drive mode selector are implausible.
6241 Signal 'Idle speed' is received despite accelerator position change.
2742 Signal of pressure sensor is implausible.
2842 Signal from temperature sensor (for control unit) is implausible.
2942 Signal from transmission oil temperature sensor is implausible.
3042 Sensor 'Gear' leaves position without active shifting.
3142 Sensor 'Gate' leaves position without active shifting.
3242 Sensor 'Range' leaves position without active shifting.
3342 Sensor 'Split' leaves position without active shifting.
3442 'Transmission input speed signal' faulty, frequency fault
3542 Speed sensor for output speed 1 delivers faulty signal.
3642 Speed sensor for output speed 2 delivers faulty signal.
3742 Speed sensor for output speed 1 + 2 delivers faulty signal.
4442 Clutch position sensor not within permissible range
5242 Signal 'Speed difference of the front wheels' on CAN bus is not present or is faulty.
7942 The 'ABS control' signal from control unit EBS Electronic brake system is invalid.
8042 The 'ASR active' signal from control unit EBS Electronic brake system is invalid.
8142 The 'front axle speed' signal from control unit BS is invalid.
8242 Failure of both signal sources for front axle speed
8342 Signal 'Retarder actual torque' on CAN bus is not present or is faulty.
8442 Signal 'Insufficient cooling' on CAN bus is not present or is faulty.
8642 The 'retarder lever position' signal from control unit INT is invalid.
8842 Signal 'Engine parameter' on CAN bus is not present or is faulty.
8942 Cruise control signal error
9042 The 'engine speed' signal from control unit FR drive control is invalid.
9242 No CAN message 'Actual engine torque' from control module FR or message is faulty.
9342 No CAN message 'Current engine torque' from control module FR or message is faulty.
9442 CAN signal 'Current intarder torque in percent' from control unit INT is faulty.
9542 No CAN message 'Specified engine torque' from control module FR or message is faulty.
9642 The 'idle throttle switch' signal from control unit FR drive control is invalid.
9742 The 'service brakes' signal from control unit BS is invalid.
9842 The 'kickdown' signal from control unit FR is invalid.
9942 CAN error: Cruise control ACTIVE
6644 Temperature of control unit ASG too high.
5716 The driving switch has an internal fault.
3941 Sensor values are implausible.
6342 Signal 'NOx sensor' on CAN bus is not present or is faulty.